Grandstream GXW42xx User Manual Manual de usuario

GXW42XX User Manual www.grandstream.com Firmware Version 1.0.5.8 [email protected] Grandstream Networks, Inc. Analog IP Gateway GXW

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 8 OF 62 WARRANTY Grandstream has a reseller agreement with our reseller customers. End u

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 9 OF 62 CONNECT YOUR GXW42XX GATEWAY Connecting the GXW42XX gateway is easy. Before you

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 10 OF 62

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 11 OF 62 FIGURE 1: DIAGRAM OF GXW4216/24/32/48 PANEL TABLE 1: DEFINITIONS OF THE GXW CONNECT

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 12 OF 62 Pin Signal Pin Signal 1 RING1 26 TIP1 2 RING2 27 TIP2 3 RING3 28 TIP3 4 RING4 29 TIP4 5

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 13 OF 62 connected.  For GXW4224 and GXW4248, the last pair of pin 25 and 50 on each RJ21 is not

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 14 OF 62 This page is intentionally left bank

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 15 OF 62 GXW42XX FEATURES The GXW42XX is a next generation IP voice gateway that is interoperable

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 16 OF 62 Concurrent Calls (except when using SRTP) Voice over Packet Capabilities Voice Activity D

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 17 OF 62 header DHCP Server/Client DHCP Client only DHCP Client only DHCP Client only DHCP Client o

This page is intentionally left bank

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 18 OF 62 TFTP, TELNET, PPPoE, STUN TFTP, TELNET, PPPoE, STUN TFTP, TELNET, PPPoE, STUN TFTP, TE

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 19 OF 62 EMC EN55022/EN55024 and FCC part15 Class B Safety UL Compliance FCC, CE, C-Tick GXW42XX L

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 20 OF 62 This page is intentionally left bank

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 21 OF 62 BASIC OPERATIONS UNDERSTANDING GXW VOICE PROMPTS GXW42XX has a built-in voice prompt men

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 22 OF 62 Address new IP address. 015 Upgrade Protocol Upgrade protocol for firmware and config

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 23 OF 62 2. Dial the number directly and press # (Use # as dial key” must be configured in web con

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 24 OF 62 the default destination port 5060 is used if no port is specified. b) If the target IP a

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 25 OF 62 the transfer has been successful, nor does it indicate the transfer has failed. It often

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 26 OF 62 model has - i.e. each port can be its own Hunting Group. The most practical and ef

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 27 OF 62 Please be aware, the choice of 1 for ports 2 and 3, the choice of 4 for ports 5 and 6, th

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 1 OF 62 GXW42XX USER MANUAL INDEX GNU GPL INFORMATION ...

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 28 OF 62 feature. For example, on the GXW42XX inter-port calling is achieved by dialing *** and

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 29 OF 62 CALL FEATURES GXW42XX supports the traditional telephony features available in a PBX as w

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 30 OF 62 *90 Busy Call Forward: Dial “*90” and then the forwarding number followed by “#”. Wait f

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 31 OF 62 CONFIGURATION GUIDE CONFIGURING GXW42XX VIA VOICE PROMPT DHCP MODE Select voice menu opt

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 32 OF 62 ACCESS THE WEB CONFIGURATION MENU The GXW42XX HTML configuration menu can be accessed via

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 33 OF 62 1. STUN Server (under Advanced Settings webpage) Enter a STUN Server IP (or FQDN) that yo

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 34 OF 62 access settings can be set here.  PROFILE - AUDIO SETTINGS: DTMF, Vocoder, and Analog Li

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 35 OF 62 NAT Traversal Shows type of NAT the GXW42XX is connected to via its WAN port. It is based

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 36 OF 62 STUN server The IP address or Domain name of the STUN server. Only non-symmetric NAT route

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 37 OF 62 Config File Prefix This field enables user to store different configuration files in one s

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 2 OF 62 SENDING AND RECEIVING FAX ...

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 38 OF 62 Periodic Inform Interval Frequency that the inform packets will be sent out to the ACS Con

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 39 OF 62 Primary RADIUS Authentication Port Default is 1812. Specifies the port to be used for the

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 40 OF 62 Self-Defined Time Zone This parameter allows the users to define their own time

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 41 OF 62 time in ms) while OFF is the period of silence. In order to set a continuous ring, OFF sho

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 42 OF 62 Failover SIP Server Failover SIP Server’s IP address or Domain name provided by

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 43 OF 62 periodically (every 20 seconds) send a blank UDP packet (with no payload data) to the SIP

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 44 OF 62 Local SIP Port Defines the local SIP port the GXW42XX will listen and transmit. The defaul

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 45 OF 62 SIP REGISTER Contact Header Uses Default is LAN Address. If set to WAN Address, device wil

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 46 OF 62 Check SIP User ID for Incoming INVITE If set to "Yes", SIP User ID will be chec

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 47 OF 62 Preferred Vocoder The GXW42XX supports up to 5 different Vocoder types including

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 3 OF 62 TABLE OF FIGURES GXW42XX User Manual Figure 1: Diagram of GXW4216/24/32/48 Panel ...

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 48 OF 62 Jitter Buffer Type Select either Fixed or Adaptive based on network conditions. Jitter Buf

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 49 OF 62 Call Settings Early Dial Default is No. Use only if proxy supports 484 response. This pa

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 50 OF 62 { ^1900x. | <=1617>[2-9]xxxxxx | 1[2-9]xx[2-9]xxxxxx | 011[2-9]x. | [3469]11 } Expl

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 51 OF 62 Disable Visual MWI Visual message indicator is a special on-hook caller ID type

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 52 OF 62 SRTP Feature Default is Yes, and star code is Enable-16, Disable-17. SRTP per call Feature

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 53 OF 62 Play registration id Feature Default is Yes, and active star code is 98. Forced Codec Feat

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 54 OF 62 Authenticate ID SIP service subscriber’s Authenticate ID used for authentication. C

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 55 OF 62 CONFIGURATION THROUGH A CENTRAL SERVER Grandstream GXW42XX can be automatically configur

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 56 OF 62 This page is intentionally left bank

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 57 OF 62 SOFTWARE UPGRADE Software upgrade can be done via either TFTP or HTTP/HTTPS. Th

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 4 OF 62 GNU GPL INFORMATION GXW42XX firmware contains third-party software licensed under the GNU

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 58 OF 62  Grandstream’s latest firmware is available http://www.grandstream.com/support/firmware.

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 59 OF 62 FIRMWARE AND CONFIGURATION FILE PREFIX AND POSTFIX Firmware Prefix and Postfix allows dev

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 60 OF 62 This page is intentionally left bank

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 61 OF 62 RESTORE FACTORY DEFAULT SETTING FACTORY RESET WARNING!Restoring the Factory Default Sett

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 62 OF 62 A: 22 (press the “2” key twice, “A” will show on the LCD) B: 222 C: 2222 D: 33 (press th

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 5 OF 62 CHANGE LOG This section documents significant changes from previous versions of G

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 6 OF 62 in the initial REGISTER. CHANGES FROM 1.0.4.4 USER MANUAL  Added option [Enable LLDP] t

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 7 OF 62 WELCOME Thank you for purchasing the Grandstream GXW42XX Analog FXSIP Gateway. The GXW42X