Grandstream GXW400x User Manual Manual de usuario descargar pdf (Pagina 35)

FIRMWARE VERSION 1.0.14.1 GXW400X USER MANUAL Page 33 of 60

LAN DHCP Start IP

Default is 100

LAN DHCP End IP

Default is 199

DHCP IP Lease Time

Value is set in units of hours. Default value is 120 hrs (5 Days.) The time IP

address is assigned to the LAN clients.

DMZ IP

Forward all WAN IP traffic to a specific IP address if no matching port is used by

GXW400X or defined in port forwarding.

Port Forwarding

Forwards a matching (TCP/UDP) port to a specific LAN IP address with a specific

(TCP/UDP) port.

In addition to the Basic Settings configuration page, end users also have access to the Device Status

page.

TABLE 8: STATUS PAGE

MAC Address

The device ID in hexadecimal format. This is needed for Internet Service Provider

troubleshooting. Note: there are separate MAC addresses for the WAN side and the

LAN side. The LAN MAC address will be used for provisioning and can be found on the

label on original box and on the label located on the bottom panel of the device.

WAN IP Address

Shows WAN IP address of GXW400X

Product Model

Contains the product model info.

Software Version

Program: This is the main software release. Boot and Loader are not changed often.

System Up Time

Shows system uptime since the last reboot.

PPPoE Link Up

Shows whether the PPPoE connection is running if connected to DSL modem.

NAT

Shows type of NAT the GXW400X is connected to via its WAN port. It is based on

STUN protocol.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 61 62

Sin comentarios

Grandstream GXW400x User Manual Manual de usuario Pagina 35